Configuring the Initial SSR Cluster (SRC CLI)
Configuring your initial cluster is a multistep process that requires you to install your C Series Controllers, load the SRC software, and perform the following configuration steps.
For information about supported cluster configurations see Supported SSR Cluster Configurations.
 | Note: This procedure assumes that you are configuring the cluster for the first time and as such, the SSR database is already in maintenance mode. |
To configure your initial SSR cluster:
- Configure the cluster ID.
- Configure the cluster geometry.
- Configure the role of each node in the cluster
- Configure the management servers.
See Configuring the Management Servers in the SSR Cluster (SRC CLI).
- (Optional) Make desired changes to the default subscriber
sessions table.
See Configuring the Fields in the Subscriber Sessions Table (SRC CLI).
- (Optional) If you are configuring the two-shared-data-node
geometry, configure the database memory size.
See Configuring the Database Memory Size When Running the Two-Shared-Data-Node Geometry (SRC CLI).
- (Optional) Make desired changes to the default attribute
associations table.
See Mapping SAE Plug-In Attributes to Fields in the Subscriber Sessions Table (SRC CLI).
- Commit the configuration.
See Committing a Configuration and Exiting Configuration Mode.
- Enable the component database (must be done on each node in the SSR cluster.)
- Create the SSR database. (There is no need to destroy the database because it does not exist at initial startup).
- Enable each SSR client component.
- Verify status of the cluster.
- Place the cluster into production mode.
See Placing the SSR Database into Production Mode (SRC CLI).
