Enabling the Juniper Networks Database to Run in Community Mode (SRC CLI)

If you are adding a Juniper Networks database to an existing community, see Adding a Juniper Networks Database to an Established Community (SRC CLI).

Use the following configuration statements to enable the Juniper Networks database on a C Series Controller in community mode:

To enable the Juniper Networks database to run in community mode:

1. From configuration mode, access the configuration statement that configures the Juniper Networks database in community mode:
   user@host# edit system ldap server community
2. Specify the role of the database as primary or secondary:
   [edit system ldap server community] user@host# set role primary

   or

   [edit system ldap server community] user@host# set role secondary
3. Configure primary neighbors. Specify each neighbor by IP address, fully qualified hostname, or a hostname that can be resolved through the domain name system:
   [edit system ldap server community] user@host# set primary-neighbors neighbor ...

   For example, set C1 and C2 as primary neighbors:

   [edit system ldap server community]

   user@host# set primary-neighbors C1 C2

4. Specify the connection type of the configured primary neighbors as clear or secure:
   [edit system ldap server community] user@host# set primary-connection-type clear

   or

   [edit system ldap server community] user@host# set primary-connection-type secure

   Where:

   • clear—Sets LDAP as a data replication protocol between SRC and the LDAP nodes that are configured in the primary neighbors.
   • secure—Sets LDAPS as a data replication protocol between SRC and the LDAP nodes that are configured in the primary neighbors.
5. Configure secondary neighbors. Specify each neighbor by IP address, fully qualified hostname, or a hostname that can be resolved through the domain name system:
   [edit system ldap server community] user@host# set secondary-neighbors neighbor ...

   For example, set C3 and C4 as secondary neighbors:

   [edit system ldap server community]

   user@host# set secondary-neighbors C3 C4

6. Specify the connection type of the configured secondary neighbors as clear or secure:
   [edit system ldap server community] user@host# set secondary-connection-type clear

   or

   [edit system ldap server community] user@host# set secondary-connection-type secure

   Where:

   • clear—Sets LDAP as a data replication protocol between SRC and the LDAP nodes that are configured in the secondary neighbors.
   • secure—Sets LDAPS as a data replication protocol between SRC and the LDAP nodes that are configured in the secondary neighbors.