Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Unpacking the C Series Controller

    Before you begin unpacking the item, be sure you have the following tools:

    • No. 2 Phillips screwdriver
    • Utility knife
    • Mechanical lift, or at least one person to assist in lifting

    The system is shipped in a cardboard carton and secured with foam packing material. The carton also contains an accessory box and quick start instructions.

    Note: The controller is maximally protected inside the shipping carton. Do not unpack it until you are ready to begin installation.

    Warning: Three people are required to install the system in a rack: two to lift it into position and one to screw it to the rack.

    To unpack the controller:

    1. Move the shipping carton to a staging area as close to the installation site as possible, but where you have enough room to remove the controller.
    2. Position the carton so that the arrows are pointing up.
    3. Open the top flaps on the shipping carton.
    4. Remove the accessory box, and verify the contents against the parts inventory on the label attached to the carton.
    5. Pull out the packing material holding the controller in place.
    6. Verify the contents of the carton against the packing list included with the controller.
    7. Save the shipping carton and packing materials in case you later need to move or ship the controller.

    Published: 2014-06-12