[ Contents] [ Prev] [ Next] [ Report an Error]

OC48/STM16 POS IOA

IOA label ES2-S1 OC48 STM16 POS IOA
Number of IOA ports
  • 1
Software release
  • First supported: 7.0.1
Description
  • 30 W
  • Half-height module
  • See Slot Combinations for more information on combining IOAs in a slot.
  • Unchannelized, concatenated OC48/STM16 for POS
Capability
  • OC48/STM16
  • HDLC framing
Software features
  • See OCx/STMx POS IOAs for information about the layer 2 and layer 3 protocols and applications that this module combination supports.
Line module compatibility
  • ES2 4G LM
SRP module compatibility
  • SRP-100
  • SRP-320
Line module redundancy compatibility
  • Can be paired with an ES2 4G LM.
  • Must be installed in the same redundancy group as an ES2 4G LM and ES2–S1 REDUND IOA combination.
Module redundancy support
  • Yes (Redundancy IOA must be installed in either slot 0 or slot 11)
Port redundancy support
  • Not applicable
Cables and connectors (single-mode short reach [SR-1])
  • Up to one LC full duplex connector
  • Transmit power:
    • min: –10 dBm
    • max: –3 dBm
  • Center wavelength: 1310 nm
  • Receive input power:
    • min: –18 dBm
    • max: –3 dBm
  • Rated for 2 km (1.2 miles) of 9-micron core cable
  • See E320 Hardware Guide, Chapter 5, Cabling the Router for more information.
Cables and connectors (single-mode intermediate [IR-1])
  • Up to one LC full duplex connector
  • Transmit power:
    • min: –5 dBm
    • max: 0 dBm
  • Center wavelength: 1266 through 1310 nm
  • Receive input power:
    • min: –18 dBm
    • max: –0 dBm
  • Rated for 15 km (9.3 miles) of 9-micron core cable
  • See E320 Hardware Guide, Chapter 5, Cabling the Router for more information.
Cables and connectors (single-mode long reach [LR-2])
  • Up to one LC full duplex connector
  • Transmit power:
    • min: –2 dBm
    • max: 3 dBm
  • Center wavelength: 1550 through 1580 nm
  • Receive input power:
    • min: –28 dBm
    • max: –9 dBm
  • Rated for 80 km (24.9 miles) of 9-micron core cable
  • See E320 Hardware Guide, Chapter 5, Cabling the Router for more information.
LEDs Board-level LEDs:
  • OK (green)—Physical link is connected properly and is functioning properly
  • FAIL (red)—Failure detected

Port LEDs:
  • ALM—Bi-color LED:
    • Yellow: Local loss of signal exists
    • Red: Remote loss of signal exists
  • OK (green)—SONET is up and port is functioning properly. If not lit, a problem exists.
Alarms, errors, and events
  • See Monitoring SONET/SDH Interfaces in JUNOSe Physical Layer Configuration Guide, Chapter 4, Configuring Unchannelized OCx/STMx Interfaces.

[ Contents] [ Prev] [ Next] [ Report an Error]