[Contents] [Prev] [Next] [Index] [Report an Error]

Unpacking the ERX-1400 Series

The ERX-1400 series come boxed, bolted, and strapped to a skid. See Figure 2-1.

For your convenience, we recommend that you unpack the ERX system in the location where you want to install it.

Figure 2-1 Packaged ERX-1400 series

To unpack the ERX-1400 series:

  1. Cut the two straps that secure the carton to the skid. See Figure 2-1.
  2. Open the carton from the top.
  3. Remove the box of accessories that sits on top of the router.
  4. Unlock the four plastic clips that hold the box to the skid by squeezing them in their center and pulling out. See Figure 2-1.
  5. Lift the carton off the router. See Figure 2-2.

Figure 2-2 Lifting the carton off an ERX-1400 series
  1. Use a Phillips screwdriver to remove the three screws (10-32 x 3/8 in) that attach each of the two L-brackets to the router.
  2. To move the router more easily from the skid, unscrew one of the L-brackets from the skid by removing the three screws that attach it to the skid. See Figure 2-3.

Figure 2-3 Removing an L-bracket
  1. Depending on where you want to position the system, proceed to Freestanding Installation or Rack-Mounted Installation, later in this chapter.

[Contents] [Prev] [Next] [Index] [Report an Error]