Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Grounding the Junos Pulse Gateway

    Note: This step is not required for the MAG2600. Grounding is provided with the three-prong power cord.

    You ground the device by connecting a grounding cable to earth ground and then attaching it to the chassis grounding points using UNC 1/4-20 two screws. You must provide the grounding cables (the cable lugs are supplied with the device).

    1. Verify that a licensed electrician has attached the cable lug provided with the device to the grounding cable.
    2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to an approved site ESD grounding point. See the instructions for your site.
    3. Ensure that all grounding surfaces are clean and brought to a bright finish before grounding connections are made.
    4. Connect the grounding cable to a proper earth ground.
    5. Detach the ESD grounding strap from the site ESD grounding point.
    6. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
    7. Place the grounding cable lug over the grounding points on the upper rear of the chassis. The bolts are sized for UNC 1/4-20 bolts.
    8. Secure the grounding cable lug to the grounding points, first with the washers, then with the screws.
    9. Dress the grounding cable and verify that it does not touch or block access to device components, and that it does not drape where people could trip on it.

    Published: 2011-07-25