Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    AC Power Cord Specifications for the Junos Pulse Gateway

    Each AC power supply for the Junos Pulse Gateway has a single AC appliance inlet located on the power supply that requires a dedicated AC power feed. Most sites distribute power through a main conduit that leads to frame-mounted power distribution panels, one of which can be located at the top of the rack that houses the Junos Pulse Gateway. An AC power cord connects each power supply to the power distribution panel.

    Each detachable AC power cord is 2.5 meters (approximately 8 feet) long. The appliance coupler at the female end of the cord inserts into the AC appliance inlet on the faceplate of the AC power supply. The coupler type is C19 as described by the International Electrotechnical Commission (IEC) standard 60320. The plug at the male end of the power cord fits into the power source outlet that is standard for your geographical location.

    Note: In North America, AC power cords must not exceed 4.5 meters (approximately 15 feet) in length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian Electrical Code (CEC) Section 4-010(3). The cords shipped with the Junos Pulse Gateway are in compliance.

    Table 1 lists the AC power cord specifications for the Junos Pulse Gateway for the countries and regions listed in the table.

    Table 1: AC Power Cord Specifications for the Junos Pulse Gateway

    Country/Region

    Electrical Specifications

    Plug Standards

    Australia

    250 VAC, 15 A, 50 Hz

    AS/NZS 3112

    China

    250 VAC, 16 A, 50 Hz

    GB 1002

    Europe (except Italy, Switzerland, and United Kingdom)

    250 VAC, 16 A, 50 Hz

    CEE (7) VII

    Italy

    250 VAC, 16 A, 50 Hz

    CEI 23-16

    Japan

    250 VAC, 16 A, 50 Hz

    NEMA L6–20

    North America

    125 VAC, 15 A, 50 Hz

    NEMA 5–15

    Switzerland

    250 VAC, 16 A, 50 Hz

    SEV 1011 SEV 5934/2

    United Kingdom

    250 VAC, 13 A, 50 Hz

    BS 1363/A

    Figure 1 shows the plug on the power cord for each country and region listed in Table 1.

    Figure 1: AC Plug Types

    Image g020529.gif

    Caution: The AC power cord for the Junos Pulse Gateway is intended for use with the Junos Pulse Gateway only and not for any other use.

    Figure 2: Power Cable Warning (Japanese)

    Image g017253.gif

    Warning: The switch is pluggable type A equipment installed in a restricted-access location. It has a separate protective earthing terminal provided on the chassis in addition to the grounding pin of the power supply cord. This separate protective earthing terminal must be permanently connected to earth ground.

    Published: 2011-07-25