Navigation
Table of Contents
Guide That Contains This Content
[+] Expand All
[-] Collapse All
Removing an MX2020 SFB
To remove an SFB (see Figure 1):
 | Note: You can remove the SFB as a unit. |
 | Caution: Before removing an SFB, ensure that you know how to operate the ejector handles properly to avoid damage to the equipment. |
- Place an electrostatic bag or antistatic mat on a flat, stable surface.
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Open the ejector handles outward simultaneously to unseat the SFB.
- Grasp the ejector handles, and slide the SFB about halfway out of the chassis.
- Place one hand underneath the SFB to support it, and slide it completely out of the chassis.
- Place the SFB on the antistatic mat or into an antistatic bag.
- If you are not replacing the SFB immediately, install a blank panel over the empty slot.
Figure 1: Removing an SFB
