Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Edit and Delete LSPs

You can edit the parameters configured for tunnels (label-switched paths (LSPs)) and delete LSPs which you no longer need.

Edit LSPs

To edit the parameters configured for an LSP:

  1. Select Network > Topology.

    The Topology page is displayed with the topology map at the center and the network information table at the bottom of the page.

  2. In the Tunnel tab, select the check box corresponding to the LSP for which you want to edit the parameters, and click the Edit icon.

    The Edit Tunnel page appears, displaying the same fields that are presented when you add an LSP.

  3. Modify the parameters as needed. Based on the type of LSP that you selected, see Add a Single LSP, Add Diverse LSPs, or Add Multiple LSPs for more information on these parameters.
    Note:

    You can modify only some fields when you are editing LSPs.

  4. Click Edit to save your changes.

    You are returned to the Topology page, where a confirmation message appears on the top of the page, indicating that an edit tunnel change request was successfully created. The request is automatically approved and deployed on the devices, after which the LSP parameters are updated.

Delete LSPs

To delete one or more LSPs:

  1. Select Network > Topology.

    The Topology page is displayed with the topology map at the center and the network information table at the bottom of the page.

  2. In the Tunnel tab, select the check box corresponding to the LSPs that you want to delete, and click the Delete icon.

    An alert message appears, asking you to confirm the delete operation.

  3. Click OK.

    You are returned to the Topology page, where a confirmation message appears, indicating that the selected LSP is deleted.