100-Gigabit Ethernet OTN PIC with CFP2 (PTX Series)

Software Release

PTX5000: Junos OS Release 14.1R2 and later

Hardware Features

Four ports that can be configured as 100-Gigabit Ethernet, 100-Gigabit OTN, or a combination of 100-Gigabit Ethernet and 100-Gigabit Ethernet OTN interfaces.
Model number: P2-100GE-OTN
Name in the CLI: 4x100GE OTN CFP2
Power requirements: 14.50A@ –12 V (176 W)
Large maximum transmission units (MTUs): up to 9500 bytes

Software Features

100-Gigabit Ethernet OTN PIC with CFP2 (PTX Series) shows the first supported release for each software feature.

Table 1: Software Features Supported
Software Feature	First Supported Junos OS Release on PTX5000
Flexible Ethernet services encapsulation	14.1R2
Flexible VLAN tagging	14.1R2
IFINFO / IFMON	14.1R2
IEEE 802.1 ag OAM	14.1R2
IEEE 802.3 ah OAM	14.1R2
IEEE 802.3ad link aggregation	14.1R2
Interrupt-driven link-down detection for MPLS FRR	14.1R2
MAC accounting per logical interface for source addresses	14.1R2
MAC filter per port for destination addresses and source addresses	14.1R2
MAC filter per logical interface for source addresses	14.1R2
SNMP	14.1R2
Up to 4000 logical interfaces shared across all ports on a single PFE	14.1R2

Cables and Connectors

The following transceivers are supported on this PIC:

CFP2-100G-LR4-D—Supports both 100GBASE-LR4 and OTU4 4I1-9D1F
- Cable: See 100-Gigabit Ethernet 100GBASE-R Optical Interface Specifications or 100-Gigabit Ethernet OTN Optical Interface Specifications
- Connector: LC
CFP2-100G-SR10-D—Supports 100GBASE-SR10

Note:
This transceiver supports Ethernet only, OTN is not supported.
- Cable: See 100-Gigabit Ethernet 100GBASE-R Optical Interface Specifications
- Connector: 24-fiber MPO
CFP2-100GBASE-LR4—Supports 100GBASE-LR4
- Cable: See 100-Gigabit Ethernet 100GBASE-R Optical Interface Specifications
- Connector: LC
CFP2-100GBASE-SR10—Supports 100GBASE-SR10
- Cable:
- Connector: 24-fiber MPO

LEDs

The STATUS LED is located to the left of the ONLINE/OFFLINE button. One LED is located next to each port to indicate the link activity of the port. 100-Gigabit Ethernet OTN PIC with CFP2 (PTX Series) describes the functions of these LEDs.

Table 2: 100-Gigabit Ethernet OTN PIC with CFP2 LEDs
Label	Color	State	Description
STATUS	Green	On steadily	PIC is online with no alarms or failures.
	Yellow	On steadily	PIC is initializing.
	Red	On steadily	PIC is in failed state.
	–	Off	PIC is offline or not enabled.
Single LED per port, labeled 0, 1, 2, and 3	Green	On steadily	Port is online with no alarms or failures, and the link is up.
	Green	Blinking	Activity detected. Port is sending or receiving packets.
	Red	On steadily	Port is on but the link is down, and the port has detected a failure with alarms.
	–	Off	Port is off or not enabled.

ON THIS PAGE