Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Configuring PCEP on a PE Router (from CLI)

 

A Path Computation Client (PCC) supports the configurations related to the Path Computation Element (PCE) and communicates with the CSD-Topology, which by default is configured to accept a Path Computation Element Protocol (PCEP) connection from any source address. However, you must configure PCEP on each PE router to configure the router as a PCC and establish a connection between the PCC and the CSD-Topology. A PCC initiates path computation requests, which are then executed by the CSD-Topology.

The following requirements apply for each PCC in the network that the CSD-Topology can access:

  • The corresponding JSDN package (with PCEP support) is installed on the router.

Note

You must boot the PCC router with the Junos OS 14.2X1.1 image, and then boot the router a second time with the JSDN image. After the router boots up a second time, the router (functioning as a PCC) is able to support the configurations related to the PCE and communicate with the CSD-Topology.

Note

For a PCEP connection, the PCC can connect to the CSD-Topology using an in-band or out-of-band management network, provided that IP connectivity is established between the Path Computation Server (PCS) and the specified PCEP local address. In some cases, an additional static route might be required from the CSD-Topology to reach the PCC, if the IP address is unreachable from the CSD-Topology default gateway.

To configure a PE router as a PCC:

  1. Enable external control of LSPs from the PCC router to the CSD-Topology.
  2. Specify the loopback address of the PCC router as the local address, for example:
    Note

    As a best practice, the router ID is usually the loopback address, but is not necessarily configured this way.

  3. Specify the CSD-Topology (csdtopology) as the PCE that the PCC connects to, and specify the CSD-Topology host external IP address as the destination address.
  4. Configure the destination port for the PCC router that connects to the CSD-Topology (PCE server) using the TCP-based PCEP.
  5. Configure the PCE type.
  6. Enable LSP provisioning.
  7. To verify that PCEP has been configured on the router, open a telnet session to access the router, and run the following commands:

    Sample output:

    Sample output:

Related Documentation