100-Gigabit Ethernet OTN PIC with CFP2 (PTX Series)
Software Release
PTX5000: Junos OS Release 14.1R2 and later
Hardware Features
Four ports that can be configured as 100-Gigabit Ethernet, 100-Gigabit OTN, or a combination of 100-Gigabit Ethernet and 100-Gigabit Ethernet OTN interfaces.
Model number: P2-100GE-OTN
Name in the CLI: 4x100GE OTN CFP2
Power requirements: 14.50A@ –12 V (176 W)
Large maximum transmission units (MTUs): up to 9500 bytes
Software Features
Table 1 shows the first supported release for each software feature.
Table 1: Software Features Supported
Software Feature | First Supported Junos OS Release on PTX5000 |
|---|---|
Flexible Ethernet services encapsulation | 14.1R2 |
Flexible VLAN tagging | 14.1R2 |
IFINFO / IFMON | 14.1R2 |
IEEE 802.1 ag OAM | 14.1R2 |
IEEE 802.3 ah OAM | 14.1R2 |
IEEE 802.3ad link aggregation | 14.1R2 |
Interrupt-driven link-down detection for MPLS FRR | 14.1R2 |
MAC accounting per logical interface for source addresses | 14.1R2 |
MAC filter per port for destination addresses and source addresses | 14.1R2 |
MAC filter per logical interface for source addresses | 14.1R2 |
SNMP | 14.1R2 |
Up to 4000 logical interfaces shared across all ports on a single PFE | 14.1R2 |
Cables and Connectors
The following transceivers are supported on this PIC:
CFP2-100G-LR4-D—Supports both 100GBASE-LR4 and OTU4 4I1-9D1F
Cable: See 100-Gigabit Ethernet 100GBASE-R Optical Interface Specifications or 100-Gigabit Ethernet OTN Optical Interface Specifications
Connector: LC
CFP2-100G-SR10-D—Supports 100GBASE-SR10
Note This transceiver supports Ethernet only, OTN is not supported.
Cable: See 100-Gigabit Ethernet 100GBASE-R Optical Interface Specifications
Connector: 24-fiber MPO
CFP2-100GBASE-LR4—Supports 100GBASE-LR4
Cable: See 100-Gigabit Ethernet 100GBASE-R Optical Interface Specifications
Connector: LC
CFP2-100GBASE-SR10—Supports 100GBASE-SR10
Cable:
Connector: 24-fiber MPO
LEDs
The STATUS LED is located to the left of
the ONLINE/OFFLINE button. One LED is located
next to each port to indicate the link activity of the port. Table 2 describes the functions of
these LEDs.
Table 2: 100-Gigabit Ethernet OTN PIC with CFP2 LEDs
Label | Color | State | Description |
|---|---|---|---|
| Green | On steadily | PIC is online with no alarms or failures. |
Yellow | On steadily | PIC is initializing. | |
Red | On steadily | PIC is in failed state. | |
– | Off | PIC is offline or not enabled. | |
Single LED per port, labeled | Green | On steadily | Port is online with no alarms or failures, and the link is up. |
Blinking | Activity detected. Port is sending or receiving packets. | ||
Red | On steadily | Port is on but the link is down, and the port has detected a failure with alarms. | |
– | Off | Port is off or not enabled. |