Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Performance Management Overview

    In performance management (PM), the Connectivity Services Director application provides an option to measure the frame delay, frame loss, frame delay variation, and service availability. These measurements are achieved in either of the following ways:

    • Triggering a one-way delay

    • Triggering a two-way delay

    • Loss

    The performance measurement is useful for generating periodic service level agreement conformance reports from the deployed network and for studying traffic patterns in the network over a period of time. The iterator profiles are configured on remote MEP for measurement of frame delay (ETH-DM), frame loss (ETH-LM) and statistical frame loss (SFL).

    Monitoring Performance Statistics

    The PM statistics can be collected in the following two ways:

    1. On-Demand Mode

    2. Proactive Mode

    Note: The Connectivity Services Director application supports only the on-demand mode.

    On-Demand Mode

    In on-demand mode, you can trigger the measurements. You can also collect loss measurement (ETH-LM) and delay measurements (ETH-DM).

    Loss Measurement

    The frame loss is calculated by collecting the counter values applicable for ingress and egress service frames. The counters maintain a count of transmitted and received data frames between a pair of MEPs. The loss measurement statistics are retrieved as the output of the monitor ethernet loss-measurement command and are also stored at the initiator. The frame counts are stored at both the initiator and the receiver MEPs for later retrieval.

    The on-demand loss measurement statistics is collected for point-to-point service only. There are two linear charts: Near-End-CIR and Far-End-CIR. For each interval, the graph plots three values: Average case, best case, and worst case frame loss.

    Delay Measurement

    To start an ethernet frame delay measurement session, the router initiates an exchange of frames carrying one-way or two-way frame delay measurement protocol data units (PDUs) between the local and remote MEPs. Ethernet frame delay measurement statistics are measured and stored at only one of the MEPs.

    For one-way ethernet frame delay measurement, only the receiver MEP (on the remote system) collects statistics. For two-way Ethernet frame delay measurement, only the initiator MEP (on the local system) collects statistics.

    The on-demand delay measurement statistics are collected for point-to-point and VPLS services. Either the one-way or two-way delay measurements statistics are collected for the services at a given point of time. For each interval, the graph plots three value: Average delay, best case delay and worst case delay.

    Proactive Mode

    In this mode SLA measurements are triggered by an iterator application. The proactive performance monitoring is supported only on VPWS and VPLS.

    Performance Management of Test Traffic

    The Connectivity Services Director application enables you to create Threshold Crossing Alert (TCA) Profiles to apply service level agreement (SLA) parameters to test traffic as defined by the following standards:

    • L2 Ethernet OAM/ ITU-T Y.1731

    • RFC2544

    Specifically, the parameters are:

    • Bandwidth Utilization

    • Delay

    • Delay Variation—Jitter

    • Frame Loss

    • Throughput

    See Creating a TCA Profile.

    Modified: 2017-09-13