Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation  Back up to About Overview 
  
[+] Expand All
[-] Collapse All

Resolved Issues

The following issues are resolved in Connectivity Services Director Release 2.1R1. For each entry, the identifier in the PR Number column of Table 3 is the tracking number in the Juniper Networks problem report (PR) tracking system.

Table 3: Resolved Issues in Connectivity Services Director Release 2.1R1

PR Number

Problem Description

1262213

Transit service applied BGP prefix limit to the BGP protocol instead of peer group.

1262216

You cannot specify a BGP authentication key for a peer having an IPv4 or an IPv6 address from the Connectivity Services Director application.

1262678

OSPF domain ID was rejected with the message Value does not contain a valid AS number prefix of range 1 - 65536.

1263598

Connectivity Services Director displayed the following error message when an existing P2P service order is modified and submitted:

Provider VlanId not modifiable in Service. Interface xe-0/2/8(3866879).

1264686

CoS template created from Connectivity Services Director 2.0R5 was not applied on all devices on L3VPN.

1264687

The status of services is displayed as Down for all services on the Service Summary page.

1267718

Routing instance configuration that is present in devices evn after the services are removed.

1272976

Connectivity Services Director release 2.0R4 identified NNI as UNI during prestage job.

1274579

View Physical Inventory page incorrectly showed the slots in MX104 router as empty.

1275828

When trying to select end points to set up services on an MX104 router, the interface were unavailable.

1280320

Device status in Junos Space Network Management Platform showed as In-Sync, while the devices in Connectivity Services Director showed as Out Of Sync.

1271581

When a service order decommission job is in Scheduled state and it gets cancelled following a server restart, the service order could not be deleted from the system.

1247227

A generic error message is displayed if the deployment of a VPLS service with Traffic Type as Transport VLAN fails. The generic error message must be replaced with the following appropriate error message:

Specify CVLAN start and CVLAN end values.

1238027

If the AS number is greater than 65535, you must append Route Target or Route Distinguisher values with “L”. Connectivity Services Director fails to recover a service with such Route Target or Route Distinguisher values.

1244763

In the Topology view, the status of Layer 3 links are not dynamically updated.

1258324

In the Topology view, optical inline amplifiers (ILAs) are displayed on optical links only after a delay of 15 seconds.

1257863

While modifying a Layer 3 VPN service if you select a device to associate a policy, the policy is listed only if you have associated the policy with a device at the time of policy creation.

1243315

A device you deleted while modifying a Layer 3 VPN service appears in the Create Policy page.

1250579

If you modify the ASN value on a device, the new ASN value is not updated in the Connectivity Services Director application.

Modified: 2017-08-16