Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Remove an ACX710 Router

Power Off an ACX710 Router

Before you power off an ACX710 router:

  • Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage. See Prevention of Electrostatic Discharge Damage.

  • Ensure that you do not need to forward traffic through the router.

  • Ensure that you have the following parts and tools available to power off the router:

    • An ESD grounding strap

    • An external management device such as a PC

    • An RJ-45 to DB-9 rollover cable to connect the external management device to the console port

To power off your ACX710 router:

  1. Connect to the router from an external management device using one of the following methods:
  2. Shut down Junos OS from the external management device by issuing the request system halt operational mode CLI command.
  3. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other end of the strap to an ESD point.
  4. Disconnect power to the router by switching the circuit breaker on the panel board that services the DC circuit to the off position.
  5. Remove the power source cable by gently pulling out the power cord that is connected to the power supply module.
  6. Disconnect all cables from the router before removing it from the rack or cabinet.

Remove an ACX710 Router from a Rack or Cabinet

Before removing your ACX710 router from its rack:

If you need to relocate an installed ACX710 router, use the procedure described in this topic.

Note:

When you remove multiple devices from a rack, remove the device in the top of the rack first, and proceed to remove the rest of the devices from top to bottom.

  • Ensure that the rack is stable and secured to the building.

  • Ensure that there is enough space to transport the removed router along the path to the new location and to place the router in its new location.

  • Read General Safety Guidelines and Warnings.

  • Use the appropriate power-off sequence to safely power off the device. See Power Off an ACX710 Router.

  • Disconnect the power cords.

  • Ensure that you have disconnected any cables or wires attached to the router ports.

To remove an ACX710 router from a rack or cabinet:

  1. Have one person support the weight of the router while another person uses the screwdriver to remove the front mounting screws that attach the chassis mounting rails to the rack or cabinet.
  2. Slowly slide the router out of the rack, with the mounting rails attached to its sides.
  3. Use the screwdriver to remove the mounting screws that attach the mounting blades that are attached to the rear of the rack or cabinet.
  4. Place the removed screws and mounting blades in a labeled bag. You will need them when you reinstall the router.
  5. Transport the router to your new location.