[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Removing an SCB

To remove an SCB (see Figure 46):

Note: The SCB and Routing Engine are removed as a unit. You can also remove the Routing Engine separately.

  1. Power off the device. See Powering Off the Services Gateway.
  2. Place an electrostatic bag or antistatic mat on a flat, stable surface.
  3. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage.
  4. Rotate the ejector handles simultaneously counterclockwise to unseat the SCB.
  5. Grasp the ejector handles and slide the SCB about halfway out of the chassis.
  6. Place one hand underneath the SCB to support it and slide it completely out of the chassis.
  7. Place the SCB on the antistatic mat.
  8. If you are not replacing the SCB now, install a blank panel over the empty slot.

Figure 46: Removing an SCB

Image g030247.gif


[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]