[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Disconnecting the Alarm Relay Wires

To disconnect the alarm relay wires from the services gateway and an alarm-reporting device (see Figure 41):

  1. Disconnect the existing wire at the external device.
  2. Using a 2.5-mm flat-blade screwdriver, loosen the small screws on the face of the terminal block and remove the block from the relay contact.
  3. Using the 2.5-mm flat-blade screwdriver, loosen the small screws on the side of the terminal block. Remove existing wires from the slots in the front of the block.

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]