[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Connecting Power to an AC-Powered Services Gateway

Caution: Do not mix AC and DC power supplies within the same services gateway. Damage to the device might occur.

You connect AC power to the device by attaching power cords from the AC power sources to the AC appliance inlets located on the power supplies. The power cords are provided. For power cord specifications, see AC Power Cord Specifications.

To connect the AC power cords to the device for each power supply (see Figure 35):

  1. Locate the power cords shipped with the device, which should have a plug appropriate for your geographical location (see AC Power Cord Specifications).
  2. Move the AC switch next to the appliance inlet on the power supply to the off position (O).
  3. Insert the appliance coupler end of the power cord into the appliance inlet on the power supply.
  4. Insert the power cord plug into an external AC power source receptacle.

    Note: Each power supply must be connected to a dedicated AC power feed and a dedicated external circuit breaker. We recommend that you use a 15 A (250 VAC) minimum, or as permitted by local code.

  5. Dress the power cord appropriately. Verify that the power cord does not block the air exhaust and access to device components, or drape where people could trip on it.
  6. Repeat Step Step 1 through Step Step 5 for the remaining power supplies.

Figure 35: Connecting AC Power to the Services Gateway

Image g004221.gif


[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]