[ Contents] [ Prev] [ Next] [ Report an Error]

Installing a DC Power Supply

To install a DC power supply:

  1. Ensure that the voltage across the DC power source cable leads is 0 V and that there is no chance that the cable leads might become active during installation.
  2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage.
  3. Orient the power supply as follows:

    Figure 2: Installing a DC Power Supply, SRX 3400

    Image g036085.gif

    Figure 3: Installing a DC Power Supply, SRX 3600

    Image g036087.gif

  4. Using both hands, slide the power supply straight into the chassis until the power supply is fully seated in the chassis slot. The power supply faceplate should be flush with any adjacent power supply faceplate.

See Connecting Power to a DC-Powered Services Gateway for information on connecting the power supply to DC power.


[ Contents] [ Prev] [ Next] [ Report an Error]