Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Configuring GVRP (NSM Procedure)

    As a network expands and the number of clients and VLANs increases, VLAN administration becomes complex, and the task of efficiently configuring VLANs on multiple switches becomes increasingly difficult. To automate VLAN administration, you can enable GARP VLAN Registration Protocol (GVRP) on the network.

    GVRP learns VLANs on a particular 802.1Q trunk port, and adds the corresponding trunk port to the VLAN if the advertised VLAN is preconfigured or existing already on the switch. For example, a VLAN named “sales” is advertised to trunk port 1 on the GVRP-enabled device. The device adds trunk port 1 to the sales VLAN if the sales VLAN already exists on the switch.

    As individual ports become active and send a request to join a VLAN, the VLAN configuration is updated and propagated among the switches. Limiting the VLAN configuration to active participants reduces the network overhead. GVRP also provides the benefit of pruning VLANs to limit the scope of broadcast, unknown unicast, and multicast (BUM) traffic to interested devices only.

    To configure GVRP:

    1. In the navigation tree, select Device Manager > Devices. In Device Manager, select the device.
    2. In the configuration tree, expand Protocols.
    3. Select GVRP.
    4. Click the Add icon.
    5. Add/modify GVRP settings for the interface as specified in Table 1.

    Note: After you make changes to a device configuration, you must push that updated device configuration to the physical security device for those changes to take effect. You can update multiple devices at one time. See Updating Devices for more information.

    Table 1: GVRP Configuration Fields

    Option

    Function

    Your Action

    Disable

    Select this option to disable GVRP on the interface.

    Click to select.

    Join Timer

    Specifies the maximum number of milliseconds the interfaces wait before sending VLAN advertisements.

    Select a value.

    Leave Times

    Specifies the number of milliseconds an interface must wait after receiving a leave message to remove the interface from the VLAN specified in the message.

    Select a value.

    Leaveall Times

    Specifies the interval at which Leave All messages are sent on interfaces. Leave All messages help to maintain current GVRP VLAN membership information in the network.

    Select a value.

    Published: 2013-01-06