Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Configuring the RADIUS for Subscriber Access Management, L2TP, or PPP (NSM Procedure)

    You can configure RADIUS for subscriber access management, layer 2 tunneling protocol (L2TP), or point-to-point protocol (PPP). The servers are tried in order and in a round-robin fashion until a valid response is received from one of the servers or until all the configured retry limits are reached.

    To configure the RADIUS server in NSM:

    1. In the NSM navigation tree, select Device Manager > Devices.
    2. Click the Device Tree tab, and then double-click the device to select it.
    3. Click the Configuration tab. In the configuration tree, expand Access.
    4. Select Radius Server.
    5. Add or modify settings as specified in Table 1.
    6. Click one:
      • OK—Saves the changes.
      • Cancel—Cancels the modifications.

    Table 1: RADIUS Server Configuration Details

    TaskYour Action

    Configure the RADIUS servers.

    1. Click Add new entry next to Radius Server
    2. In the Name box, enter the profile name.
    3. In the Comment box, enter the comment.
    4. From the Accounting Port list, select the port number on which to contact the accounting server.

      Default: 1813 (as specified in RFC 2865)

    5. From the Port list, select the port number on which to contact the RADIUS server.

      Default: 1812 (as specified in RFC 2865)

    6. In the Secret box, enter the password to use with the RADIUS server. The secret password used by the local router must match that used by the server.
    7. From the Timeout list, select the amount of time that the local router waits to receive a response from a RADIUS server.

      Range: 1 through 90 seconds

      Default: 3 seconds

    8. From the Retry list, select the number of times that the router is allowed to attempt to contact a RADIUS server.

      Range: 1 through 10

      Default: 3

    9. In the Source Address box, enter a valid IPv4 address configured on one of the router interfaces.
    10. From the Routing Instance list, select the routing instance name.

    Published: 2013-01-02