Configuring Static Routes (NSM Procedure)

You can configure static routes for a routing table group. A router uses static routes in the following scenarios:

A static route is installed in the routing table only when the route is active; that is, the list of next-hop routers configured for that route contains at least one next hop on an operational interface.

To configure static routes for a routing table group in NSM:

  1. In the navigation tree, select Device Manager > Devices.
  2. In the Devices list, double-click the device to select it.
  3. Click the Configuration tab.
  4. In the configuration tree, expand Routing Options.
  5. Select Static.
  6. Add or modify the parameters as specified in Table 56.
  7. Click one:
    • OK—To save the changes.
    • Cancel—To cancel the modifications.
    • Apply—To apply the routing option settings.

Note: After you make changes to a device configuration, you must push that updated device configuration to the physical security device for those changes to take effect. You can update multiple devices at one time. See the Updating Devices section in the Network and Security Manager Administration Guide for more information.

Table 56: Static Fields



Your Action


Specifies the comment for the static route.

Enter the comment.

Rib Group

Specifies the routing table group name for which the static route is configured.

Enter the name.


Enables you to configure the global static route options. These options only set the global defaults and apply to all the configured static routes.

  1. Expand the Static tree and select Defaults.
  2. Enter the default route to the destination address.


Enables you to configure the individual static routes options. These options apply to the individual destination only and override any options configured in the Defaults section.

  1. Expand the Static tree and select Route.
  2. Enter the individual route.