ATM for Subscriber Access Encapsulation Types Overview
To enable subscriber access to an MX Series router over an ATM network, you can create any of the following configurations on Modular Port Concentrator/Modular Interface Card (MPC/MIC) interfaces that use the ATM MIC with SFP:
PPP-over-Ethernet-over-ATM (PPPoE-over ATM) with a dynamic or static PPPoE (
pp0
) subscriber interface over a static ATM underlying interfaceRouted IP-over-ATM (IPoA) with a static IPv4 or IPv6 subscriber interface over a static ATM underlying interface
Bridged IP-over-Ethernet-over-ATM (IPoE-over-ATM) with a static IPv4 or IPv6 subscriber interface over a static ATM underlying interface
PPP-over-ATM (PPPoA) with a static PPP subscriber interface over a static ATM underlying interface
Concurrent PPP-over-Ethernet-over-ATM interfaces and IP-over-Ethernet-over-ATM interfaces on a single ATM PVC
As part of the configuration procedure, you must specify the appropriate encapsulation type for your configuration on the ATM logical interface.
Table 1 lists and describes the encapsulation type you must specify
as part of the encapsulation
statement when you configure the
ATM logical interface for each supported configuration.
ATM Subscriber Access Configuration |
Encapsulation Type |
Description |
---|---|---|
PPPoE-over-ATM with dynamic |
|
PPPoE-over-ATM encapsulation with logical link control (LLC) |
PPPoE-over-ATM with static |
|
PPPoE-over-ATM encapsulation with LLC |
IP-over-ATM (IPoA) |
|
ATM subnetwork attachment point (SNAP) encapsulation for IPoA with LLC |
|
ATM VC multiplex encapsulation for IPoA with virtual circuit (VC) multiplexing |
|
IP-over-Ethernet-over-ATM (IPoE-over-ATM) and Concurrent IPoE-over-ATM and PPPoE-over-ATM subscriber interfaces on a single ATM VC |
|
Ethernet-over-ATM encapsulation with LLC |
PPP-over-ATM (PPPoA) |
|
PPP-over-AAL5 encapsulation with LLC |
|
PPP-over-AAL5 encapsulation with VC multiplexing |