show services monitoring pblq

show services monitoring pblq capabilities

The results of fields that measure duration are displayed in seconds.

NTP synched	Whether the clock is synched with NTP.
Max result stored	The maximum number of test results that the device is capable of storing.

Injector Capabilities

When the near device is in injector mode, these fields display the capabilities of the near device.

Injector Minimum Sample Interval

The minimum interval that the device samples and updates the statistics related to the test.

Generator Capabilities

When the near device is in injector mode, these fields are not applicable and are always 0.

Reflector Capabilities

These fields display the capabilities of the far device, which reflects the packets back to the near device. If the minimum duration of a stage of the test is lower than the minimum shown in the results of this RPC, the test fails.

PMD Reflector Minimum Setup Duration	Not applicable. Always 0.
PMD Reflector Minimum Teardown Duration	Not applicable. Always 0.
ASIC Reflector Minimum Setup Duration	When the reflector is in ASIC mode, the minimum time the device requires to set up the test.
ASIC Reflector Minimum Teardown Duration	When the reflector is in ASIC mode, the minimum time it takes the device to return the interface to pre-test status.

show services monitoring test-id test-id

The results of fields that measure duration are displayed in milliseconds.

Test Config

Test ID	The identification number of the test.
Role	The supported role(s) of the device you run the command on. Use the desired role when setting up the PBLQ test. For the near device, the role should be INJECTOR. For the far device, the role should be REFLECTOR.

Test Result

Pre-Sync Duration	The remote setup time. After this completes, the reflector is ready to receive packets.
Setup Duration	The minimum time it takes the devices to set up the PBLQ test.
Qualification Duration	Length of the PBLQ test.
Post-Sync Duration	How long the near device should hold up the link until the far device finishes teardown.
Teardown Duration	The minimum time it takes the device to end the test and return the interface to its pre-test state.
Packet Count	Number of packets sent during the PBLQ test.
Packet Rate (Bps)	Not applicable. Always 0.
Packet Size	Size of each packet sent during the PBLQ test in bytes. This size must be greater than the minimum MTU and less than the maximum MTU.
Expected Rate (Bps)	Not applicable. Always 0.

show services monitoring pblq capabilities

show services monitoring summary

show services monitoring pblq test-id test-id