Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Stopping the Disaster Recovery Process on Junos Space Network Management Platform Release 14.1R3 and Earlier

To configure the disaster recovery enhancements added as part of the Junos Space Network Management Platform Release 15.2R1, you must first disable the disaster recovery feature on your current Junos Space setup (Junos Space Network Management Platform Release 14.1R3 and earlier) before upgrading to Junos Space Network Management Platform Release 15.2R1. You must stop backups at the active site and the standby site must stop collecting backups from the active site. The scripts to stop the backup and restoration process configured during earlier releases are stored at /opt/jmp-geo/backup/script/ and /opt/jmp-geo/restore/script/.

Stopping the Backup Process at the Active Site

Stopping the backup process at the active site removes the cron job and stops the backup operation from being performed.

To stop the backup process at the active site:

  1. Log in to the CLI of the Junos Space node at the active site on which the VIP or the eth0:0 interface is configured.

    The Junos Space Settings Menu is displayed.

  2. Enter 6 (if you are using a hardware appliance) or 7 (if you are using a virtual appliance) at the Junos Space Settings Menu prompt to run shell commands.

    The following is a sample output from a virtual appliance:

    You are prompted to enter the administrator password.

  3. Enter the administrator password.
  4. Type /opt/jmp-geo/backup/script/./backup.sh stop at the shell prompt and press Enter.

    The following is a sample output:

The backup process at the active site is stopped.

Stopping Collecting Backups from the Active Site

Stopping the restoration process at the standby site removes the cron job and stops collecting backups from the active site.

To stop the restoration process at the standby site:

  1. Log in to the CLI of the Junos Space node at the active site on which the VIP or the eth0:0 interface is configured.

    The Junos Space Settings Menu is displayed.

  2. Enter 6 (if you are using a hardware appliance) or 7 (if you are using a virtual appliance) at the Junos Space Settings Menu prompt to run shell commands.

    The following is a sample output from a virtual appliance:

    You are prompted to enter the administrator password.

  3. Enter the administrator password.
  4. Type /opt/jmp-geo/restore/script/./restore.sh stopPoll at the shell prompt and press Enter.

    The following is a sample output:

The standby site stops collecting backups from the active site.