HP ProCurve
You can integrate an HP ProCurve device with JSA to record all relevant HP Procurve events using syslog.
Take the following steps to configure your HP ProCurve device to forward syslog events to JSA.
Log into the HP ProCurve device.
Type the following command to make global configuration level changes.
config
If successful, the CLI will change to the following prompt:
ProCurve(config)#
Type the following command:
logging <syslog-ip-addr>
Where: <syslog-ip-addr> is the IP address of JSA.
To exit config mode, press CTRL+Z.
Type the following command: write mem to save the current configuration to the startup configuration for your HP ProCurve device.
You are now ready to configure the log source in JSA.
Syslog Log Source Parameters for HP ProCurve
If JSA does not automatically detect the log source, add a HP ProCurve log source on the JSA Console by using the syslog protocol.
When using the syslog protocol, there are specific parameters that you must use.
The following table describes the parameters that require specific values to collect syslog events from HP ProCurve:
Parameter |
Value |
---|---|
Log Source Name |
Type a name for your log source. |
Log Source Description |
Type a description for the log source. |
Log Source type |
HP ProCurve |
Protocol Configuration |
Syslog |
Log Source Identifier |
Type the IP address or host name for your HP ProCurve appliance. |