Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
ON THIS PAGE
 

Fast Track to Rack Installation and Power

This procedure guides you through the simplest steps to install your SRX1600 Firewall in a rack and connect it to power. Have more complex installation needs? See Install the SRX1600 in a Rack.

Install the SRX1600 in a Rack

You can install the SRX1600 Firewall in a four-post rack or cabinet. We’ll walk you through the steps to install an AC-powered firewall in a square-hole four-post rack.

Before you install, review the following:

  1. Wrap and fasten one end of the electrostatic discharge (ESD) cable grounding strap around your bare wrist, and connect the other end to a site ESD point.
  2. Attach the side-mounting brackets to the chassis. Align the keyholes of the mounting brackets over the shoulder screws of the chassis and slide the mounting brackets towards the rear of the chassis.
  3. Assemble the mounting rails by sliding the rear rails into the front rails.
  4. Align the guide blocks of the rear-mounting rail with the rear-post holes. Pull the rear-mounting rail toward the front of the rack to lock the rail in place. You'll hear a distinct click when the latch locks into the rack holes.
  5. Align the guide blocks of the front-mounting rail with the front-post holes. Push the front-mounting rail toward the rear of the rack to lock the rail in place. You'll hear a distinct click when the latch locks into the rack holes.
  6. Ensure that the front and rear latches on the mounting rails are locked in place.
  7. Lift the device and position it in the rack, aligning the side-mounting brackets with the mounting rails. Slide the device into the channels of the mounting rails.
  8. Tighten the two thumbscrews to secure the device.

Connect to Power

To connect the SRX1600 Firewall to AC power, you must do the following:

Ground the SRX1600 Firewall

To ground the SRX1600 Firewall, do the following:

  1. Wrap and fasten one end of the electrostatic discharge (ESD) cable grounding strap around your bare wrist, and connect the other end to a site ESD point.

  2. Connect the grounding cable to a proper earth ground, such as the rack in which you mount the device.

  3. Place the grounding cable terminal attached to the grounding cable over the grounding point.

  4. Secure the grounding cable terminal to the grounding point using the M5 screws.

  5. Dress the grounding cable. Ensure that the cable doesn’t block access to or come in contact with other device components, and that it doesn’t drape where people could trip over it.

Connect the Power Cord and Power On the Firewall

For information about the supported AC power cord specifications, see Supported AC Power Cords.

To connect the power cord, do the following:

  1. Ensure that the power supply is fully inserted in the rear panel of the firewall.

  2. Insert the coupler end of the power cord into the AC power cord socket on the rear panel.

  3. Push the power cord retainer on to the power cord.

  4. If the AC power source outlet has a power switch, turn it off.

  5. Plug the power cord into an AC power source outlet.

  6. If the AC power source outlet has a power switch, turn it on. The firewall doesn't have a power switch and powers on as soon as you plug it in.