Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Installing the MX2020 Air Baffle

To install the air baffle—MX2000-UPR-BAFFLE:

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  2. Close the upper fan tray access door.
  3. Align the holes on the air baffle with the holes located on either side of the upper fan tray access door, (see Figure 1).
  4. Tighten the four captive screws to secure the air baffle to the upper fan tray access door. Use #2 Phillips screwdriver. Do not overtighten. Do not apply more than 8.0 lb-in (0.90 Nm) of torque to the captive screws
  5. An air baffle can have fixed or adjustable louvers. Fixed louvers are set at an angle of 10-degrees. You must set adjustable louvers at a 10-degree upward tilt/angle to direct the exhaust air away from the router, (see Figure 2).
Figure 1: Installing the Air BaffleInstalling the Air Baffle
Figure 2: Air Baffle Louvers Adjusted at 10 Degrees Angle Air Baffle Louvers Adjusted at 10 Degrees Angle