[ Contents] [ Prev] [ Next] [ Report an Error]

Adaptive Services II Layer 2 Services PIC

Image g002318.gif

Software release

JUNOS 7.5 and later (Type 1)

The Adaptive Services II Layer 2 Services PIC is not supported by T640 routing nodes connected to a TX Matrix platform.

Description

Supports Layer 2 Service package only. Tunnel services are included with the PIC. Other services require an individual license.

Power requirement: 0.4 A @ 48 V (19 W)

Hardware features

Support for up to 2000 service sets

Support for MTUs up to 9192 bytes for Gigabit Ethernet and SONET interfaces

Software features Depending on your JUNOS release and individual licenses, software features for this PIC can include the features listed in Table 4. For more information about the software features available for services PICs, see the JUNOS Services Interfaces Configuration Guide.

LEDs Status LED, one tricolor:

Off—PIC is offline and it is safe to remove it from the chassis.

Green—PIC is operating normally.

Amber—PIC is initializing.

Red—PIC has an error or failure and no further harm can be done by removing it from the chassis.

Application LED, one bicolor:

Off—Service is not running.

Green—Service is running under acceptable load.

Amber—Service is overloaded.

Table 4: Adaptive Services PICs Software Features

Software Feature Adaptive Services II PIC Adaptive Services II Layer 2 Services PIC

GRE Key – –

GRE dont-fragment – –

Stateful firewall with packet inspection: detects SYN attacks, ICMP and UDP floods, and ping-of-death attacks 6.4 –

Network Address Translation (NAT) for IP addresses 6.4 –

Port Address Translation (PAT) for port numbers 6.4 –

IP Security (IPSec) encryption 6.4 –

Flow monitoring exports cflowd version 5 and version 8 records 7.0 –

Flow monitoring exports flow monitoring version 9 records, based on RFC 3954 (IP v4 templates only) 8.3 –

Passive flow monitoring – –

Passive flow collection – –

Flow-tap 8.1 –

Dynamic flow capture – –

Real-time performance monitoring 8.3 –

Link Services 7.3 7.5

Tunnel services:

IP-IP unicast tunneling

GRE unicast tunneling—Supports GRE fragmentation

Protocol Independent Multicast (PIM) sparse mode unicast tunneling

6.4 7.5

Virtual tunnel interface for Layer 3 VPNs 6.4 –

Layer 2 Tunneling Protocol (L2TP) – –

Voice services:

Compressed Real-Time Transport Protocol (CRTP)

7.3 7.5

Encapsulations:

Multilink Frame Relay (MLFR)

Multilink Point-to-Point Protocol (MLPP)

7.1 –

[ Contents] [ Prev] [ Next] [ Report an Error]

Description	Supports Layer 2 Service package only. Tunnel services are included with the PIC. Other services require an individual license. Power requirement: 0.4 A @ 48 V (19 W)
Hardware features	Support for up to 2000 service sets Support for MTUs up to 9192 bytes for Gigabit Ethernet and SONET interfaces
Software features	Depending on your JUNOS release and individual licenses, software features for this PIC can include the features listed in Table 4. For more information about the software features available for services PICs, see the JUNOS Services Interfaces Configuration Guide.
LEDs	Status LED, one tricolor: Off—PIC is offline and it is safe to remove it from the chassis. Green—PIC is operating normally. Amber—PIC is initializing. Red—PIC has an error or failure and no further harm can be done by removing it from the chassis. Application LED, one bicolor: Off—Service is not running. Green—Service is running under acceptable load. Amber—Service is overloaded.

Software Feature	Adaptive Services II PIC	Adaptive Services II Layer 2 Services PIC
GRE Key	–	–
GRE dont-fragment	–	–
Stateful firewall with packet inspection: detects SYN attacks, ICMP and UDP floods, and ping-of-death attacks	6.4	–
Network Address Translation (NAT) for IP addresses	6.4	–
Port Address Translation (PAT) for port numbers	6.4	–
IP Security (IPSec) encryption	6.4	–
Flow monitoring exports cflowd version 5 and version 8 records	7.0	–
Flow monitoring exports flow monitoring version 9 records, based on RFC 3954 (IP v4 templates only)	8.3	–
Passive flow monitoring	–	–
Passive flow collection	–	–
Flow-tap	8.1	–
Dynamic flow capture	–	–
Real-time performance monitoring	8.3	–
Link Services	7.3	7.5
Tunnel services: IP-IP unicast tunneling GRE unicast tunneling—Supports GRE fragmentation Protocol Independent Multicast (PIM) sparse mode unicast tunneling	6.4	7.5
Virtual tunnel interface for Layer 3 VPNs	6.4	–
Layer 2 Tunneling Protocol (L2TP)	–	–
Voice services: Compressed Real-Time Transport Protocol (CRTP)	7.3	7.5
Encapsulations: Multilink Frame Relay (MLFR) Multilink Point-to-Point Protocol (MLPP)	7.1	–