JATP700 Appliance Front Panel Description
Figure 1 shows the front
panel components of the JATP700 appliance.
Figure 1: JATP700 Front Panel
Table 1 lists
the front panel components of the JATP700 appliance.
Table 1: JATP700 Front Panel Components
Callout | Component | Description |
---|
1 | Front Bezel | Protects the appliance. |
2 | Lock | Locks the appliance. |
3 | Power button | Powers on or powers off the appliance. |
4 | Hard drive | Eight 900 GB hard disk drives (Drive0 - Drive7). |
5 | Hard drive | Empty slots (Drive8 - Drive15). |
6 | RESET button | Reboots the appliance. |
7 | Chassis LEDs | Provides the colors and states, and the status they indicate. |
Figure 2 shows the
front panel LEDs of the JATP700 appliance.
Figure 2: JATP700 Front Panel
LEDs
Table 2 lists the
front panel LEDs of the JATP700 appliance.
Table 2: JATP700
Front Panel LEDs
Callout | LEDs | Description |
---|
1 | Power | |
2 | GLAN2 | - Flashing—Indicates activity.
- Steady—Indicates link.
|
3 | Alert/Power fail | Red—Indicates a power supply failure. Amber—Indicates that the appliance is operating normally.
The LED might glow amber if a rescue configuration is not set. This
is not a panic condition. |
4 | Hard drive | Off. This LED is not used. |
5 | GLAN1 | - Flashing—Indicates activity.
- Steady—Indicates link.
|
6 | Information | - Red (blinking)—Indicates a fan failure.
- Red (slowly blinking)—Indicates a power failure.
That is, the power is received but the power supply is not functioning.
Check for a non-operational power supply.
- Solid red—Indicates an overheat condition, which
might be caused due to obstruction to the airflow in the system -
for example, by cables or due to increase in the ambient temperature.
You can perform the following checks: - Check the routing of the cables if they are obstructing
the airflow from the system.
- Ensure that all fans are present and operating normally.
- Ensure that the chassis covers are installed.
- Solid blue —Indicates User ID (UID) function is
activated. Use this function to locate the server in a rack mount
environment.
- Blue (blinking)—Indicates Remote UID is on. Use
this function to identify that the server is used from a remote location.
|
Table 3 lists the
JATP700 hard disk drive port LEDs.
Table 3: JATP700
HDD Port LEDs
LEDs | Description |
---|
Status (left) | - Solid red—Indicates failed drive for SAS/SATA/NVMe
with RSTe support.
- Red (blinking):
- At 1 Hz—Indicates rebuild drive for SAS/SATA with
RSTe support.
- Two blinks and one stop at 1 Hz—Indicates hot spare
for SAS/SATA with RSTe support.
- On for five seconds, then off—Indicates power on
for SAS/SATA with RSTe support.
- At 4 Hz—Indicates identify drive for SAS/SATA with
RSTe support.
|
Activity (right) | - Solid blue—Indicates that the SAS drive is installed.
- Blue (blinking)—Indicates the I/O activity.
|
Modified: 2018-02-06