Installing JSA Risk Manager

You can install JSA Risk Manager after you prepare your appliance.

1. Select normal for the type of setup. Select Next and press Enter.
2. Select your time zone continent or area. Select Next and press Enter.
3. Select your time zone region. Select Next and press Enter.
4. Select an Internet Protocol version. Select Next and press Enter.
5. Select the interface that you want to specify as the management interface. Select Next and press Enter.
6. Type your host name, IP address, network mask, gateway, primary DNS, secondary DNS, public IP, and email server.

   For network parameter information, see Network Parameter Information for IPv4.

7. Select Next and press Enter.
8. Type a password to configure the JSA Risk Manager root password.
9. Select Next and press Enter.
10. Retype your new password to confirm. Select Finish and press Enter.

    This process typically takes several minutes.