Configuring Bonded Management Interfaces
You can bond the management interface on JSA hardware.
You can bond the management interfaces during the JSA installation process, or after installation by following these steps.
You can bond non-management interfaces in the JSA user interface after installation. See “Configuring network interfaces” in Juniper Secure Analytics Administration Guide for more information about configuring non-management interfaces.
Bonding modes 1 and 4 are supported. Mode 4 is the default.
You must be physically logged in to your appliance, for
example through IMM or iDRAC, for these steps. Do not use
ssh for these steps.
- Change your network setup by typing the following command:
- Select the protocol version that is used for the appliance.
- Select Yes to continue with bonded network interface configuration.
- Select interfaces to configure as bonded interfaces. The interfaces that you select must not already be configured.
- Enter the bonding options. For more information about configuring specific bonding options, see your vendor-specific operating system documentation.
- Update any network information settings as needed. Your appliance restarts automatically.
- Log in to the appliance and verify the configuration.