Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Viewing the Configlet

    In View or Design action mode, select Network > Elements > Tunnels.

    Figure 1: Tunnel Details Window

    Tunnel Details Window

    Right-click on the desired tunnel in the table, and select Configlet from the popup menu to generate its configlet in the /tmp directory. The generated configlet will be immediately available for viewing.

    Note: he configlet generated here is not saved to the LSP directory. To do so, you should run Design > Configlets/Delta > LSP Configlet as described in step 2.

    If an IP address of a node is not available, the node name may be used in its place even though this may not be allowed in the router. To fix this, you should configure IP addresses for nodes and/or links in your network. This can be done in the Properties tab of the node modification window or the Location tab of the Link Modification window.

    Here is an example of a generated configlet for node BOS, a Cisco router:

    !! BOS
    interface Tunnel1001
    description from BOS to WDC
    ip unnumbered Loopback0
    tunnel destination 10.10.10.8
    tunnel mode mpls traffic-eng
    tunnel mpls traffic-eng autoroute announce
    tunnel mpls traffic-eng priority 2 2
    tunnel mpls traffic-eng bandwidth 10000
    tunnel mpls traffic-eng affinity 0x00000000 mask 0x00000000
    tunnel mpls traffic-eng path-option 10 explicit name Tunnel1001.p0
    !
    !
    ip explicit-path name Tunnel1001.p0 enable
    next-address 10.10.10.9
    next-address 10.10.10.4
    next-address 10.10.10.8

    Modified: 2016-11-08