Add a Link

To add a link in the topology map:

Click Network > Topology.

The Topology page is displayed with the topology map at the center and the network information table at the bottom of the page.
On the Link tab, click the Add (+) icon.

The Add Link page appears.
Configure the link fields as per the Table 1.

Note:
Fields marked with asterisk (*) are mandatory.
Click Add.

A confirmation message appears stating that the request is successfully submitted. The new link is displayed under the Link tab.

Table 1: Fields on the Add Link Page
Field	Description
Properties
Name	Enter a name for the link.
Node A	Click the Node A list and select the name of the ingress (source) node from the list.
Node Z	Click the Node Z list and select the name of the egress (destination) node from the list.
Type	Select the type of link you want to add from the list.
Bandwidth AZ and ZA	Enter the bandwidth (in bps) for each direction (Node A to Z and from Z to A). You must enter a number immediately followed by K (Kbps), M (Mbps), or G (Gbps). For example, 10M signifying 10 Mbps. Note: If you enter a value without units, bps is applied.
Protocols	Select one or more protocols that you want to enable on the link. You can also enable any of the protocols listed in the Protocols table by toggling the respective button. If you do enable any of these protocols, you have the option to specify additional tunnel metrics (per direction; AZ and ZA) by clicking on the empty space under the metric. Once you are done adding the metric values, click the tick icon.