Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Mark MPLS-Enabled on Links Along Path

When tunnels are configured by the routing engine in the network, the routing engine checks the protocol on the link to determine if the link is MPLS-enabled to allow placement of the tunnel.

To enable MPLS on a link:

  1. Click File > Open Network Browser from the main menu and select the network that you want to modify.
  2. Select the Tunnel tab on the Network Info table.

    All the tunnels are listed in the table.

  3. Select the tunnels on which you want to enable MPLS.
  4. Right-click on the tunnels and select Mark MPLS-enabled on links along the path.

    A confirmation message appears that the links are successfully marked as MPLS-enabled. This will set all links as MPLS-enabled on the first configured route.

    Note:

    The links are MPLS-enabled only if the first configured route is static.