Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
ON THIS PAGE
 

Release Notes for Juniper Security Director Insights

New Features

There are no new features in Juniper Security Director Insights Release 23.1R1.

Product Compatibility

This section describes the supported hardware and software versions for Juniper Security Director Insights. For Security Director requirements, see the Security Director 23.1R1 Release Notes.

Supported Security Director Software Versions

Security Director Insights is supported only on specific Security Director software versions as shown in Table 1.

Table 1: Supported Security Director Software Versions

Security Director Insights Software Version

Compatible with Security Director Software Version

23.1R1

23.1R1
Note:

The time zones set for Security Director and Security Director Insights must be the same and synchronize the time.

Virtual Machine Specification

Security Director Insights requires VMware ESXi server version 6.5 or later to support a virtual machine (VM) with the following configuration:

  • 8 CPUs

  • 24-GB RAM

  • 1.2-TB disk space

Supported Browser Versions

Security Director and Juniper Security Director Insights are best viewed on the following browsers.

  • Mozilla Firefox

  • Google Chrome

Installation and Upgrade Instructions

For more information about installing Security Director Insights 23.1R1, see Deploy and Configure Security Director Insights with Open Virtualization Appliance (OVA) Files.

For more information about installing Security Director Insights 23.1R1 with KVM, see Install Security Director Insights With KVM virt-manager.

For Security Director Insights upgrade instructions, see Upgrade Security Director Insights

Known Issues

  • HA upgrade fails when SDI hostname has uppercase letters. PR1743770

    Workaround:

    You must disable HA, change hostname with only lowercase letters, and then enable HA again to successfully upgrade HA.

    SDI as Log Collector only (Only CLI is available)

    1. Disable HA via CLI on only primary node.

      CLI> (server) ha disable

    2. Change both primary and secondary SDI hostnames with only lowercase letters.

      CLI> (server) set hostname <...>

    3. Re-enable HA via CLI from primary node only. See Configure High Availability for Security Director Insights as Log Collector.

    4. After you have enabled HA, check CLI> (server) ha status, it should display that both the nodes are up.

    5. Perform HA upgrade from primary node. See Upgrade HA.

    SDI as analytics and Log Collector (Enable HA via GUI)

    1. Disable HA via GUI. See Disable HA.

    2. Change both primary and secondary SDI hostnames via CLI with only lowercase letters.

      CLI> (server) set hostname <...>

    3. Re-enable HA from GUI. See Enable HA.

    4. Wait till SDI HA setup is back online. GUI displays that both the nodes are up.

    5. Perform HA upgrade from primary node. See Upgrade HA.

Resolved Issues

The following are the resolved issues in Security Director Insights Release 23.1R1:

  • There is a circuit_breaking_exception while running Security Director reports. PR 1727690

  • Group By "Category" shows No Data even though there are logs with category defined and seen in the events. PR1728499