Marvis Actions for Wired, WAN, and Wireless Assurance

The type of subscription you have for your organization determines the Marvis Actions usage. The following three subscription types are required for Marvis Actions:

• Marvis for Wired

• Marvis for WAN

• Marvis for Wireless

Table 1 lists the actions available for each subscription type.

You can view Marvis Actions based on the active Marvis subscription types. The number of subscriptions for each Marvis subscription type (Wired, Wireless, or WAN) must be greater than 50 percent of the number of devices of the corresponding device type in the inventory. For example, if you have six APs in the inventory, you must have four or more active Marvis for Wireless subscriptions to be able to view all the categories applicable for the Marvis for Wireless subscription as listed in Table 1.

Marvis Actions will be enabled on the Mist portal as long as the number of subscriptions is greater than 50 percent of the number of corresponding devices in the inventory.

If you are using a trial subscription type, you can view all Marvis Actions until the trial subscription ends.

Table 1: Marvis Actions for Wired, WAN, and Wireless Assurance

Category	Action	Marvis for Wired	Marvis for WAN	Marvis for Wireless
Layer 1	Bad Cable	x	x	✓
Connectivity	Authentication Failure	✓	x	✓
	DHCP Failure	✓	x	✓
	ARP Failure	x	x	✓
	DNS Failure	x	x	✓
AP	Offline	x	x	✓
	Health Check Failed	x	x	✓
	Non-compliant	x	x	✓
	Coverage Hole	x	x	✓
	Insufficient Capacity	x	x	✓
Switch	Missing VLAN	x	x	✓
	Negotiation Mismatch	✓	x	x
	Loop Detected	✓	x	x
	Port Flap	✓	x	x
	High CPU	✓	x	x
	Port Stuck	✓	x	x
	Traffic Anomaly	✓	x	x
Other Actions	Persistently Failing Clients	✓	x	✓
WAN Edge	MTU Mismatch	x	✓	x
	Bad WAN Uplink	x	✓	x
	VPN Path Down	x	✓	x