Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Add a Destination NAT Pool

You are here: Network > NAT > Pools.

To add a destination NAT pool:

  1. Click Create > Destination NAT Pool on the upper right side of the Pools page.

    The Create Destination NAT Pool page appears.

  2. Complete the configuration according to the guidelines provided in Table 1.
  3. Click OK to save the changes. If you want to discard your changes, click Cancel.

Table 1 describes the fields on the Create Destination NAT Pool page.

Table 1: Fields on the Create Destination NAT Pool Page

Field

Action

Name

Enter the destination pool name.

Description

Enter a description for the destination pool.

Routing instance

Select a routing instance from the list.

Pool address type

Select one of the following pool address type:

  • Address & Port—Translate destination IP address or addresses and port number(s) to a specific IP address and one port number.

  • Address Range—Translate a range of destination IP addresses to another range of IP addresses. This mapping is one-to-one.

Pool address

Enter IPv4 or IPv6 address for destination pool.

Note:

This option is available only when you select Address & Port as pool address type.

Pool port

Enter a destination port value.

Range: 0 through 65535.

Note:

This option is available only when you select Address & Port as pool address type.

Start address

Enter starting address (IPv4 or IPv6) of the destination address range.

Note:

This option is available only when you select Address Range as pool address type.

End address

Enter ending address (IPv4 or IPv6) of the destination address range.

Note:

This option is available only when you select Address Range as pool address type.