About the Static Page

You are here: Network > NAT > Static.

Use tis page to configure static NAT.

Tasks You Can Perform

You can perform the following tasks from this page:

Add a static rule set and rules to it. See Add a Static Rule Set.
Edit a static rule set and its rules. See Edit a Static Rule Set.
Delete a static rule set and its rules. See Delete Static Rule Set.
Move the rules in the rules table. To do this, select a rule which you want to move and select the following options according to your choice:
- Move Up—Enables you to move the rule up in the list.
- Move Down—Enables you to move the rule down in the list.
- Move to Top—Enables you to move the rule to top of the list
- Move to Bottom—Enables you to move the rule to the bottom of the list

Table 1 describes the fields on the Static page.

Table 1: Fields on the Static Page
Field	Description
Static NAT Rule Set
From	Displays the destination NAT sort options from which the packets flow. The options available are: Routing Instance Zone Interface
Filter	Displays the filter options.
Name	Displays the name of the static NAT rule set.
From	Displays the name of the routing instance, zone, or interface from which the packets flow.
Rule	Displays the name of the rule in the selected static NAT rule set.
Description	Displays a description of the static NAT rule set.
Rules in Selected Rule-Set
Rule Name	Displays the name of the routing instance, zone, or interface to which the packet flows.
Source Addresses	Displays the source address to match the rule.
Source Ports	Displays the source port number.
Destination Addresses	Displays the destination address to match the rule.
Destination Ports	Displays the destination port number.
Prefix	Displays the static IP address prefix.
Mapped Port	Displays the destination port or port range to allow static NAT to map ports.
Upper Threshold	Displays the upper threshold value of the at which an SNMP trap is triggered.
Lower Threshold	Displays the lower threshold value of the at which an SNMP trap is triggered.
Description	Displays the description of the rule in the selected static NAT rule set.