Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

request ancp oam port-up

Syntax

Description

Simulate an ANCP Port Up message on the specified access loop for troubleshooting or to mitigate an abnormal condition. You must specify an ACI, an ARI, and an outer VLAN tag. This command is overridden by a genuine ANCP Port Down message, meaning that you cannot use this command to initiate a Port Up condition when the access node has already reported a Port Down condition.

Options

aci

ANCP Access-Loop-Circuit-ID TLV that corresponds to a subscriber interface on the access node; used to identify the access node from which the message is simulated.

ip-address

IP address that specifies the access node from which the message is simulated.

ari

ANCP Access-Loop-Remote-ID TLV that identifies the subscriber associated with an interface on the access node; used to identify the access node from which the message is simulated.

physical-interface-name

Name of the access-facing subscriber interface that specifies the access node on whose local loop the loopback test is run.

vlan-id

ANCP Access-Aggregation-Circuit-ID-Binary TLV, the outer VLAN tag inserted by the access node on upstream traffic; used to identify the access node from which the message is simulated.

Required Privilege Level

view

Output Fields

When you enter this command, you are provided no feedback on the status of your request. You can enter the show ancp neighbor detail, show subscribers client-type vlan-oob detail, and the show subscribers summary commands before and after initiating the Port Up message to verify the operation.

Sample Output

request ancp oam port-up neighbor circuit-id remote-id outer-vlan-id

Release Information

Command introduced in Junos OS Release 16.1R4.