vmhost

Configure interface properties of the host.

• management-if0 | management-if1—Configure the host's side management interface0 or interface1.

  family (inet|inet6) address— Configure IPv4 or IPv6 parameters.

  primary-only— Configure the IP address to be used when the Routing Engine is the current primary. The configured IP address is assigned to primary RE host when the Routing Engine is the current primary. It is recommended to set this option for platforms with dual Routing Engine architecture with VM host support.

  gateway— Configure gateway IP address.

Configure management interface properties of the host.

• disable—Disable the host interface eth0, which serves as the management port

• link-mode (automatic | half-duplex | full-duplex)—Configure the link mode of the host interface eth0, which serves as the management port as half-duplex or full-duplex. You can also manually select the link mode option as either half-duplex or full-duplex.

• speed (automatic | 10m | 100m | 1g)—Configure the link speed of the host interface eth0, which serves as the management port. If you set the link speed as 10m or 100m, autonegotiation is turned off and the link speed is the speed that you specify.

Disable the automatic guest recovery by the host.

Enable ssh access to the host and enable or disable root-login to the host from guest.

• ssh—Allow ssh access

  root-login—Configure host root access through ssh

  allow | deny—Allow or deny root access through ssh.

Enable the remote syslog configuration from guest to host OS. Based on the severity configured on guest, the syslog information is logged onto the /etc/syslog.conf file on the host.

• host <host-name>—Host notified for remote syslog configuration.