Open Issues
Learn about open issues in this release for QFX Series switches.
For the most complete and latest information about known Junos OS defects, use the Juniper Networks online Junos Problem Report Search application.
General Routing
-
Misleading syslog message "L2CKT/L2VPN acquiring primaryship for primary" though no VPN/L2CKT configured on the router. PR1105459
-
The 4x25G channelized interfaces are not coming up after optics hot swap. PR1719758
-
Channelized interfaces leds are not properly represented in
show chassis led
. PR1720502 -
In a QFX51200-48YM-8C VC setup, after a a primaryship switch over fan tray of linecard might not be displayed in show chassis hardware and show chassis environment. There is no functional impact. PR1758400
-
QFX5210: dcpfe core seen at __kernel_vsyscall,tvp_watchdog,dcbcm_driver_read32,soc_dcbcm_ipoll_check,cp u_sched_update_timers. PR1790234
-
Due to a the disk failure reboot support was not added for dual disk scenario, hence system was not booting in case of disk failure on sdb (the other disk) on QFX platform. PR1800862
-
On Junos QFX5100 and EX4600 Platforms, high storage Utilisation is observed in /var/log due to uncompressed UKERN_GBL.log file. This can lead to low storage warnings and potential write errors for other system logs during that period. PR1804090
-
On all Junos QFX5000 platforms, traffic loss happens and the layer 3 interface cannot be deleted when many routes use the same layer 3 interface. QFX5000 is encapsulating the packets with the wrong DMAC(destination MAC ) and VNID(virtual network identifier) for a few IP addresses after disabling the interface. PR1808550
-
The traffic is still getting forwarded to all the interfaces mapped with concerned VLAN even after
unknown-unicast-forwarding
configuration statement is enabled on all Junos QFX10000 platforms, but it is allowed to be configured, so the command is disabled to avoid misconfiguration. PR1810120 -
On all Junos QFX5000 platforms, with ECMP (Equal Cost Multi Path) configured, when there is any routing protocol change (like ISIS cost metric change), the protocol traffic on the network is dropped. PR1823601
-
The PTX10008, PTX10002-60C, or QFX10002-60C platforms might not send back ICMPv4/v6 reply packets properly due to defects leading to misprogramming of hardware. Ping with v4/v6 from another device to the PTX10008, PTX10002-60C, or QFX10002-60C platform will fail. PR1827286
High Availability (HA) and Resiliency
-
Graceful Routing Engine Switchover (GRES) not supporting the configuration of a private route, such as fxp0 , when imported into a non-default instance or logical system. Please see KB https://kb.juniper.net/InfoCenter/index?page=content & id=KB26616 resolution rib policy is required to apply as a work-around. PR1754351
Junos XML API and Scripting
-
On all Junos platforms where snapshot is supported, when a device is rebooted from recovery mode it fails to commit configuration due to problems with slax import and device might go into amnesiac mode due commit fail. PR1717425
Routing Protocols
-
On all Junos and Junos OS Evolved platforms, multiple simultaneous Command Line Interface (CLI) sessions will lead to high Management Daemon (mgd) CPU utilization, impacting the device's reachability over the loopback interface from IS-IS nodes. PR1749850
User Interface and Configuration
-
ZTP upgrade in dual RE fails if the image name has special characters. PR1851232