ON THIS PAGE
Resolved Issues: 21.3R3
General Routing
-
On ACX5448 devices, the BFD session status goes in the Init state after the system reboots when you have both CFM and BFD configured on the system.PR1552235
-
CFMD cores could be seen if CCM configuration is changed from aggregated Ethernet IFL to physical IFL, and if the physical IFL was previously part of aggregated Ethernet bundle. PR1612212
-
Interface state gets reset after the Packet Forwarding Engine restarts. PR1613314
-
On ACX5000 devices, the local fault and remote fault signaling do not get logged on the /var/log/messages file. PR1624761
-
On ACX2000 devices, output packet statistics are not incremented on the unit even after configuring statistics. PR1627040
-
Multicast traffic drop might be seen if IGMP snooping is enabled for VLAN. PR1628600
-
Speed 10m configuration error on ACX5048 and ACX5096 devices. PR1633226
-
The storm-control rate-limit might not work with VPLS policer under IFL. PR1633427
-
IS-IS last transition time never increments. PR1634747
-
IPv6 BFD session over aggregated Ethernet might stay down on ACX5448 and ACX710 devices. PR1635020
-
Locally switched traffic might be dropped on ACX5448 device with ESI configured. PR1638386
-
The ARP request packets might be sent out from ACX device without VLAN header. PR1638421
-
L3 interface creation might fail on the ACX5448 and ACX710 devices. PR1638581
-
High priority packets might be dropped on ACX5448 devices. PR1642187
-
The copper ports on ACX5448 device might go down if loaded with copper SFP. PR1643989
-
While sending BGP NOTIFICATION messages for RFC 8538 HARD RESET, the data portion is not present at times. PR1648479
-
Due to the MAC learning limit being exceeded traffic drop might be observed in the MC-AE scenario. PR1653926
-
The LDP sessions might flap in VPLS scenario resulting in Packet Forwarding Engine errors. PR1654172
Platform and Infrastructure
-
The vmxt_lnx process generates core file at topo_get_link jnh_features_get_jnh jnh_stream_attach. PR1638166