Open Issues

Learn about open issues in this release for ACX Series routers.

For the most complete and latest information about known Junos OS defects, use the Juniper Networks online Junos Problem Report Search application.

EVPN

After configuring flexible-cross-connect-vlan-unaware in the Virtual private wire service (VPWS), routing instances are observed in the circuit cross-connect interface in the dscd state on the primary PE device. PR1585027

On the ACX5448 router, latency is observed for the host-generated ICMP traffic. PR1380145
Tx power cannot be configured using the + sign. PR1383980
The vpls-oam sessions are detected with error (RDI sent by some MEP) after changing VLANs. PR1478346
In ZTP DHCP, option012 or option host-name does not work as expected. PR1503958
On the ACX710 router, an alarm is not raised when booting the system using the recovery snapshot. PR1517221
Even though enhanced-ip is active, the following alarm is observed during ISSU:
PR1546002
In the Layer 3 VPN scenario, the CE device traffic drops on ingress PE device while resolving using default route in VRF. PR1551063
On the ACX5048 routers, entry for MAC address from which no traffic is seen for MAC age timer does not age out if there is active traffic destined for this MAC address. PR1565642
On the ACX5448 routers, the untagged traffic is being incorrectly queued and marked. PR1570899
On the ACX5448 routers, single rate three color policer does not work. PR1559665
On the ACX500 routers, service MIC does not work. PR1569103
Packets might get tagged with the default VLAN-ID and dropped at the peer under Layer 2 circuits local switching scenario. PR1574623
On the ACX5448 routers, detection time shows the default value (6.000) instead of the configured value for a single hop BFD. PR1585382