Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
ON THIS PAGE
 

Export Timing Data to Collectors

Junos Telemetry supports export of timing attributes for Precision Time Protocol (PTP) and Synchronous Ethernet (SyncE) to the collector. The data exported through native models, and the PTP data exported through the YANG model. Both periodic streaming and on-change notifications are supported. Use the following new subscription paths:

  • For PTP: /state/protocols/ptp/instances/instance[instance-index]/

  • For SyncE: /state/protocols/synce/

Note:
  1. Only gNMI is supported.
  2. For periodic streaming, the minimum interval is 2 seconds and the maximum interval is 65,535 seconds.
  3. UDP streaming telemetry isn't supported.

Configure Timing Data Export

To configure export of timing data, run the following extension service commands on the device:

  1. set system services extension-service request-response grpc ssl local-certificate certificate-id

  2. set system services extension-service request-response grpc ssl port 32767

  3. set system services extension-service notification allow-clients address 0.0.0.0/0

  4. Disable zero suppression by running the command set services analytics zero-suppression no-zero-suppression.

Platform-Specific Export Timing Data to Collectors Behavior

Use Feature Explorer to confirm platform and release support for specific features.

Use the following table to review platform-specific behaviors:

Table 1: Export Timing Data to Collectors

Platform

Difference

PTX10016

  • PTX10016 supports only SyncE. PTP is not supported on PTX10016.

  • The following leaves are not supported on PTX:

    • /ptp/instances/instance[instance-index]/ports/port[index]/unicast-negotiation-port-ds/enable
    • /ptp/instances/instance[instance-index]/globalinfo-ds/e2e-transparent-clock-ds/clock-state