show services monitoring y1564

Syntax

Description

Displays the Y.1564 performance test report (PTR). Displays information about the results of each category or state of the Y.1564-based benchmarking tests, such as terminated tests, completed tests, and active tests. You can also display summary statistics about the total number of tests of each state for a high-level, quick analysis. The values in the output displayed vary, depending on the state in which the test is passing through, when you issue the command. The detail option adds information about each iteration to the output of the command.

Options

active-tests <extensive> <detail>	Display the results of the set of tests that are currently running.
completed-tests <extensive> <detail>	Display the results of the set of tests that were successfully completed. A completed test is one that passes through all the test steps or states specified in the Y.1564 standard. A test that is marked as completed after it went through all the states from the beginning to the end can still be reported as a failed test. For example, a failed test can be a test that sends the desired number of packets, but does not receive the frames back from the other end.
terminated-tests <extensive> <detail>	Display the list of tests that were terminated or stopped. This list includes tests that failed due to various error conditions and tests that you terminated by entering the `test services monitoring y1564 test test-name stop` command. The `Status` field in the output specifies the reason for the termination of the test.
summary	Display summary output.
test-id `test-id` <detail>	Display test results for the specified unique identifier.

Required Privilege Level

view

Output Fields

Table 1: show services monitoring y1564 Output Fields
Field Name	Field Description	Level of Output
`Destination MAC address`	MAC address of the terminator.	All levels
`Direction`	Ingress or egress.	All levels
`Interface`	Network interface that is used as the packet's entry point.	All levels
`Iteration` with `Overall iteration result`	The ID of the iteration with the pass or fail result.	`test-id`
`Overall service result`	Pass or fail.	All levels
`SAT`	Service acceptance test FLR: Frame Loss Ratio FTD: Frame Transfer Delay	All levels
`Service: service-name`	Name of the service.	All levels
`Source MAC address`	MAC address of the initiator.	All levels
`Status`	Indicates whether the test is currently in progress, completed, or has been terminated. This field is displayed for tests that are in progress or were terminated by entering the `test services monitoring y1564 test <test-name \| test-id> stop` command.	All except `test-id`
`Step`	Description of which step of the test generated these statistics: TX frames—how many transmitted frames RX frames—how many received frames IR—information rate in kbps, mbps, or gbps FL—frame loss percentage FLR—frame loss ratio FTD min/avg/max—frame transfer delay minimum, average, and maximum Result—pass or fail	`test-id`
`Step duration`	How long the step lasted, in seconds	All levels
`Test id`	Unique identifier configured for the test.	All levels
`Test mode`	Mode configured for the test on the router. Test mode is: Initiate-and-Terminate: Test frames are initiated from one end and terminated at the same end. This mode requires a reflector to be configured at the peer end to enable the test frames to be returned to the source.	All levels
`Test name test-name`	Name configured for the test.	All levels
`Test start time` and `Test finish time`	Time at which the test started and finished in Coordinated Universal Time (UTC) format (YYYY-MM-DD-HH:MM:SS). A dash (-) is displayed if the test is still running.	All levels
`Test state`	State of the test that is in progress or active when the output is displayed.	All levels

ON THIS PAGE

Syntax

Description

Options

Required Privilege Level

Output Fields

Sample Output