show chassis cluster ethernet-switching status

Cluster ID

ID number (1-255) of a cluster. Setting a cluster ID to 0 is equivalent to disabling a cluster. A cluster ID greater than 15 can only be set when the fabric and control link interfaces are connected back-to-back.

Redundancy-Group

You can create up to 128 redundancy groups in the chassis cluster.

Node name

Node (device) in the chassis cluster (node0 or node1).

Priority

Assigned priority for the redundancy group on that node.

Status

State of the redundancy group (Primary, Secondary, Lost, or Unavailable).

• Primary—Redundancy group is active and passing traffic.

• Secondary—Redundancy group is passive and not passing traffic.

• Lost—Node loses contact with the other node through the control link. Most likely to occur when both nodes are in a cluster and there is a control link failure, one node cannot exchange heartbeats, or when the other node is rebooted.

• Unavailable—Node has not received a single heartbeat over the control link from the other node since the other node booted up. Most likely to occur when one node boots up before the other node, or if only one node is present in the cluster.

Preempt

• Yes: Primary Role can be preempted based on priority.

• No: Change in priority will not preempt primary role.

Manual failover

• Yes: Primary Role is set manually through the CLI.

• No: Primary Role is not set manually through the CLI.