Event Types Displayed in Marvis Actions

Marvis Actions in Juniper Data Center Assurance displays data center events received from a data center managed by Apstra Data Center Director. It also displays the alarms received from a vCenter and provides information about the health and connectivity of the virtual infrastructure in the data center network.

Note:

Though the intent-based analytics in Apstra Data Center Director supports several predefined probes, Marvis Actions in Juniper Data Center Assurance supports only a limited set of probes. Table 1 lists the predefined probes that Marvis Actions supports.

Marvis Actions doesn't display all the events that occur in the network. It displays only those events that are actionable. There could be events that might need additional troubleshooting to resolve the issue.

Table 1: Events displayed in Marvis Actions Dashboard
Event Type	Events
Layer 1 & 2	Incorrect Cabling Bad Optics Interface Flapping Link Status Mismatch Packet Discard
Connectivity	Missing Routes BGP Mismatch LAG Imbalance MLAG Imbalance BGP Flapping EVPN Host Flapping Type-3 Missing Routes Type-5 Missing Routes VXLAN Flow Lists Mismatch
Device	Config Deviation Deployment Status Mismatch Resource Health Issues Environment Health Issues
Virtual Infra	Config Mismatch Missing VLANs MTU Issues Non-Redundant Hosts VM Resource Health Issue Network Connectivity Lost
Security	802.1x Issues
Traffic Capacity	Spine Faults Critical Services Alerts Hot/Cold Interface Warning Congestion Notification Out of Sequence

Note:

Though the events "Congestion Notification" and "Out of Sequence" are displayed in Marvis Actions, information for these events will be available only in a future release of Apstra Data Center Director.