Known Issues and Limitations
The known issues addressed in the JSA 7.5.0 Update Package 5 Interim Fix 02 are listed below:
-
Upgrades to JSA 7.5.0 Update Package 5 might take an extended amount of time to complete due to glusterfs file cleanup. You must allow the upgrade to continue uninterrupted.
-
After upgrading to JSA 7.5.0 Update Package 5, WinCollect 7.X agents can experience management or configuration change errors.
-
It is possible for autoupdates to revert to a previous version of autoupdates after upgrading. This causes autoupdate to not work as intended.
After you upgrade to QRadar 7.5.0 or later, type the following command to check your autoupdate version:
/opt/qradar/bin/UpdateConfs.pl -v
-
Docker services fail to start on JSA appliances that were originally installed at JSA release 2014.8 or earlier, then upgraded to 7.5.0 Update Package 2 Interim Fix 02 or 7.5.0 Update Package 3.
Before updating to JSA 7.5.0 Update Package 2 Interim Fix 02, run the following command from the JSA Console:
xfs_info /store | grep ftype
Review the output to confirm the ftype setting. If the output setting displays "ftype=0", do not proceed with the upgrade to 7.5.0 Update Package 2 Interim Fix 02 or 7.5.0 Update Package 3.
See KB69793 for additional details.
-
After you install JSA 7.5.0, your applications might go down temporarily while they are being upgraded to the latest base image.
-
When adding a Data Node to a cluster, it must either all be encrypted, or all be unencrypted. You cannot add both encrypted and unencrypted Data Nodes to the same cluster.