Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
ON THIS PAGE
 

JIMS Installation

SUMMARY Read this section to know about the system requirements and configurations to install JIMS. You can also learn how to install JIMS on the client machine.

Specifications

Table 1: JIMS Specifications
Component OS and Kernel Versions
Supported Junos OS software releases

12.3X48-D45 or a later release
Supported Contrail Service Orchestration (CSO) release Release 3.3 or a later release
Support for Juniper Secure Edge Release 1.6.0
Maximum SRX Series devices Up to 1200
Maximum CSO platforms 10
Maximum event log sources 100
Maximum Active Directories 100
Maximum domains 25
Maximum user entries 500,000
Maximum syslog sources 200
Supported platforms Windows Server 2019, Windows Server 2016, Windows Server 2012 R2 with Windows Server 2012 R2 Updates (KB2919355 and KB2999226)
Supported Identity Sources Microsoft Active Directory on Windows Server 2012 R2 or later, Microsoft Exchange Server 2010 with Service Pack 3 (SP3)

Install JIMS

Note:

You need administrative privileges to install JIMS.
  1. Download the Juniper Identity Management Service installer from the Downloads page.
  2. Unzip the installer and certificate without modifying the target directory.
  3. Start the installation by running the installer.
  4. Click Yes to allow InstallShield to install JIMS on your system. The Welcome to the InstallShield Wizard for the Juniper Identity Management Service page appears.

    If the installation requirements are not available in your system, a message alerts you that the installation requires a system reboot. Click No to continue with the installation and reboot your system after the installation has been completed.

  5. Click Next.

    The License Agreement page appears.

  6. Review the license agreement and select I accept to proceed.
  7. Type the username and your organization name and click Next.
    The Ports page appears.
  8. Type the JIMS server's HTTPS server port number that the enforcement points use to communicate with JIMS. The default value is 443.
  9. Click Next.
    You see the Setup Type page, which gives you the option to select a complete or custom installation.
  10. Select the Complete setup option and click Next.
    The Ready to Install the Program page appears.
  11. Click Install. The JIMS application is installed by default in the location C:\Program Files (x86)\Juniper Networks.
  12. Select the Launch JIMS Administrator check box and click Finish.
    The Juniper Identity Management Service application page appears. The installation is now complete.
  13. In an earlier step if you had seen a message alerting you that a reboot is mandatory, then reboot your system now.